Previously we have shown beep with key press and LED lightening up and projects like Arduino Traffic Light, Arduino TM1637 with RTC. Here is How To Blink LED and Beep Every 1 Second With Arduino Upon Push Button Press. We Will Discuss Many Ways To Achieve The Goal Including Using RTC. Arduino has many ways to count time. Easiest we know is usage in the way we Blink a LED as basic example.
Blink LED and Beep Every 1 Second With Arduino
With this kind of code :
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 | int delay_value = 1000; int led_pin = 13; int buzzer_pin=8; int button_pin = 2; void setup() { pinMode(led_pin,OUTPUT); pinMode(buzzer_pin,OUTPUT); pinMode(button_pin,INPUT); } void loop() { digitalWrite(led_pin,HIGH); delay(1); digitalWrite(buzzer_pin,HIGH); delay(delay_value); int button_state = digitalRead(button_pin); digitalWrite(led_pin,LOW); delay(1); digitalWrite(buzzer_pin,LOW); delay(delay_value); if (button_state == HIGH) { delay_value = 100; } else { delay_value = 1000; } } |
Circuit basically only connecting the buzzer’s (+) ve pin with 8th pin on Arduino and (-) ve pin with Arduino’s GND, and push button in circuit.
---
We can actually improve the code in the way we made Piano with Arduino.
We can use this kind of way to code :
1 | http://playground.arduino.cc/Code/SimpleTimer |
As for using Real Time Clock, when the RTC chip loses power (when battery is down) it will give time as 0:0:0 and it will not count seconds (its stopped). We actually need to set the time to kick start the clock ticking. So basic catch in using a RTC is a need of basic setup. Of course, you can modify our Making a Digital Clock project and instead of 7 segment LED display’s second part, beep the buzzer.
What is the usage of such time based beep? It is basic of many operations, for example to keep time noticing while a work done at home like before going outside. We can set the beep to occur every minute or every 30 minutes. Also, we can activate a servo motor or switch on electrical devices in conjunction of using some kind of relay module. These basic projects, although may appear childish, is helpful to create your own libraries like an example shown above from Arduino Playground.
Tagged With beep arduino , arduino beep with led , arduino coding for led and buzzer with push button , arduino making a led flash and buzzer beep , beep() arduino , code for led blink with beep arduino , code to blink led in every 2 sec with push button , how to blink led only 2 times after push , when buttton pressed buzzer beep