Electronics with basic components is very important for the beginners. Here is the Most Simple Capacitor Circuit With One LED, One Capacitor and DC Power Source. It is so simple that a kid can do it. No wire or breadboard needed for this DIY electronics work. A capacitor is characterized by its capacitance. Capacitance is is the ratio of the electric charge (Q) on each conductor to the potential difference (V) between them. The SI unit of capacitance is the farad (F), which is equal to one coulomb per volt (1 C/V). We are demonstrating the one basic usage of capacitor. There are many types of capacitors, we will use the commonly seen aluminum electrolytic capacitors. Capacitor after charging once can hold some electricity after disconnecting.
Needed Components For The Simple Capacitor Circuit With One LED
As we said before, having a basic electronics kit is good idea. In the hydraulic analogy, analogous to water flowing through a pipe, electrons will flow and capacitor will work like a rubber membrane sealed inside a pipe. Water drops will fall after we stop the water flow!
We need a 470uF 25V capacitor, a colorless blue LED, a 5.5 DC volt power supply. µF is Microfarad, 1µF is 0.000001 F.
---
We talked about Breadboard Power Supply before. Battery will also work fine for this project.
Do you know what is super capacitor? We talked about Carbon aerogel. Their capacitance values are much higher but has lower voltage limits.
Video Demo of The Simple Capacitor Circuit With One LED
Long legs are positive poles. We passed the LED’s legs in between the legs of capacitor, so that positive-positive legs, negative-negative legs of capacitor and LED snugly fits. We do not say “positive” and “negative” poles for these electronic components, but cathode and anode. As younger peoples may read, we avoided too many terminologies. It does not need much explanation on how to do this easy thing.
When we applied charge, i.e. connected the legs of capacitor (positive should touch the positive pole, while negative should touch the negative pole). When we connected the poles with power supply, the LED show a bright grow. Then we disconnected the system from the power supply. The LED dimmed but remained glowing for a time.
Why we used clear blue LED? 8% of men can not see the colors properly. Too low intensity may not perceived by many. Here is the video :
